Local Storage seems to be disabled in your browser.
For the best experience on our site, be sure to turn on Local Storage in your browser.
5S 50A 18.5V 21V high current 3.6V Li-ion Lithium Battery BMS 18650 Charger Protection Board (for 5 Cells in Series 50A)
Product description:
The lithium battery protection board uses a highly integrated intelligent lithium battery protection board integrated chip, the performance is better than the protective board composed of discrete chips. Can complete 5 string polymer lithium battery, ternary lithium battery, lithium iron phosphate, lithium cobalt oxide, lithium manganese oxide battery charge, and discharge protection, over current, short circuit, over-temperature protection, and equalization function.
It adopts 4 milliohms ultra-low internal resistance MOS tube, which has low internal resistance and high efficiency. It is suitable for battery pack applications in different fields such as inverters, DC motors, power tools, and solar street lights.
Specification:
-
Charging/Discharge Current: 50A (When more than 20A, please add tin on the back of the PCB to increase the current pass capability.)
-
Single-cell Overcharge Protection Voltage: 4.25V ±0.025V;Single-cell Overcharge Relieved Voltage: 4.15V ±0.05V; Overcharge Protection Delay: 1S ±200mS
-
Single-cell Over-discharge Protection Voltage: 2.7V ±0.05V; Single-cell Over-discharge Relieved Voltage: 3.0V ±0.1V; Over-discharge Protection Delay: 1S ±200mS
-
Short circuit Protection: Yes; Short circuit Protection Delay: 250uS ±50uS; Short circuit Protection Recovery Mode: Disconnect the load recovery output voltage
-
Balance Function: Yes; Balance Turn-on Voltage: 4.18V ±0.025V; Balance Current: 55mA; Power Failure Protection: Yes; Temperature Protection: Yes (valid when external 10K ohm NTC resistor is connected)
-
Please select the appropriate protection board according to the actual battery type and series connection.
-
Before the protection board is installed, the battery must be matched well, and the old and new batteries cannot be mixed.
-
Please remove the cable before wiring, and connect all the wires, and then confirm that the wiring is correct before plugging in the cable. When wiring, the control wiring diagram is gradually connected from the negative pole of the battery. For the thick line, please select the appropriate square wire according to the actual load current value.
-
When the working current is too large, please add tin to the tinned part of the front and back of the protection board, or thicken the copper wire to increase the overcurrent capability of the circuit board.
-
If you need a temperature protection function, add 10K NTC resistor (refer to the image). The factory default is no temperature protection resistor.
Subtitle | N/A |
---|---|
UPC/EAN | 4604046157573 |
M.R.P | ₹1,020.00 |
Count | N/A |
Brand Name | CentIoT |
Model | BM052-5S-50A-3.6V-liion |
Whoesale | Available |
Supply Voltage | N/A |
Output Voltage | N/A |
Color | N/A |
Dimension | N/A |