Local Storage seems to be disabled in your browser.
For the best experience on our site, be sure to turn on Local Storage in your browser.
Passive Speaker piezoelectric Buzzer Module with PCB and Protection - for Arduino and Raspberry pi
- Buy 100 for ₹69.00 each and save 39%
- Buy 1000 for ₹62.00 each and save 45%
This module consists of a passive piezo buzzer and 3 male header pins. You can use it generate tones between 1.5 to 2.5kHz by switching it on and off repeatedly at different frequencies either using delays or PWM.
Product description:
-
Operating voltage 3.3V-5V
-
Tone Generation Range 1.5kHz ~ 2.5kHz
-
With a fixed bolt hole for easy installation
-
Small PCB board size: 3.2cm * 1.3cm
When the I / O port input high, the buzzer sounds Module
Interface Description (3-wire):
1.VCC external 3.3V-5V voltage (5v microcontroller can be directly connected
2.to the microcontroller and 3.3v) External GND GND
3.I / O external microcontroller IO port
ARDUINO CODE
The following Arduino sketch will generate two different tones by rapidly turning on and off the buzzer at different frequencies using a delay.
int buzzer = 8;
// set the buzzer control digital IO pin void setup() { pinMode(buzzer, OUTPUT);
// set pin 8 as output } void loop() { for (int i = 0;
i < 100;
i++) { // make a sound digitalWrite(buzzer, HIGH);
// send high signal to buzzer delay(1);
// delay 1ms digitalWrite(buzzer, LOW);
// send low signal to buzzer delay(1);
} delay(50);
for (int j = 0;
j < 100;
j++) { //make another sound digitalWrite(buzzer, HIGH);
delay(2);
// delay 2ms digitalWrite(buzzer, LOW);
delay(2);
} delay(500);
}
Subtitle | N/A |
---|---|
UPC/EAN | 4604046158785 |
M.R.P | ₹300.00 |
Count | 1 |
Brand Name | CentIoT |
Model | AR100-PAS-BUZ-W-PROT |
Whoesale | Available |
Supply Voltage | N/A |
Output Voltage | N/A |
Color | N/A |
Dimension | N/A |