Local Storage seems to be disabled in your browser.
For the best experience on our site, be sure to turn on Local Storage in your browser.
G-NiceRF LoRa serial RF module - LORAWAN node RF module - LN610 100mW Wireless Data transmission RF module
LN610 is the LoRaWAN node module. LG1301-PF/ LG1301-SE are LoRaWAN gateways. LN610 works with LG1301 to build a LoRaWAN system. This LoRaWAN system integrated the protocol of LoRAWAN V1.0 and support class C. When data input to LN610, LN610 will transmit to LG1301. When received the data from LG1301, LN610 will output the received data to the series interface. All wireless communication complies with the LoRaWAN protocol. Either LG1301-PF or LG1301-SE can be worked with LN610. The detail of these two gateways refer to the datasheet of the gateway
Feature and Application:
Feature:
• LoRaWAN protocol Class C supported
• Uart interface
• Long range
• AES128 encryption
• 8 channel communication simultaneously
• Configurable parameters
• OTAA & ABP
• Long range & Small size
• ADR
• EU433M / EU868M / KR920M / AS923M / CN780M/ CN470M / US915M / AS915M
Application:
• Smart city
• Smart Metering ( Water, Electric, Gas meter )
• Agricultural Monitoring
• Irrigation control
• Internet of Things (IoT)
• M2M
• Wireless Sensors
• Wireless Alarm and Security Systems
Specification:
★ Note: the following parameters are VCC = 3.3, with 50-ohm copper axis test instrumentation
Function Description:
1) Power on Reset
After powered up, both the Red and Blue led will blink 1 time than off.
1) Sleep mode
In this mode, LN610 works with minimal current consumption. It will not respond to the inputted wireless and UART data. Pull high CS pin, LN610 will leave this mode.
2) Normal Working Mode
In this mode, LN610 can communicate with GW1301. The TX LED(Red) will blink once when one packet is transmitted out. And RXLED(Blue) will blink once when one packet is received and verified no problem.
3) Setting mode
In normal working mode, pull low the SET pin to make LN610 enter into setting mode. Both of the TXLED and RXLED will turn on to indicate.
In setting mode,the parameters of uart will fix to:
baud_rate = 9600, data_bit = 8, parity_bit = None, stop_bit = 1;
Pin and Dimension:
Pin definition:
Mechanical dimension:
Subtitle | N/A |
---|---|
UPC/EAN | 4604046162041 |
Count | N/A |
M.R.P | ₹2,008.00 |
Brand Name | CentIoT |
Model | N/A |
Whoesale | Available |
Supply Voltage | N/A |
Dimension | N/A |
Working voltage range | 3.3V |
Data transfer rate | N/A |
Receiving sensitivity | -132dBm |
Maximum output power | N/A |
Sleep current | <2 μA |
Receiving current | 18 mA |
Operating Temperature Range | -40 to 85 deg cels |
Data Rate | N/A |
Operating Temperature | N/A |
Frequency | N/A |