2 Pin 10mm DC Female no welding switch LED Strip Connector For SMD5050 Single Color Led Lights to DC power adapter

• For waterproof LED strip light, peel off silicon/gel on the surface around the soldering line area and gently slide in the strip light into the connector body and you'll feel the connector grab the ribbon; 

• For non-waterproof LED strip light, slide in the ribbon and make sure positive and negative poles match. 

• Thicken your strip light by adding an extra chip in between and make sure the built-in soldering point touches your strip light tightly if you feel there is a loose connection.

Specification:

• Use for 10mm width SMD 5050 single color led strip

• DC connector: Female (match with 5.5*2.1mm male connector)

• Strip connector: for SMD 5050 2 pins

• Total length:30cm