Dual on and off Time Delay Adjustable relay Switch - Infinite Loop Timer Timing Cycle Control Module

Product description:

Specification:

1. 220V cycle on/off relay module; With start/stop function, the module enters the infinite loop mode after starting, and the relay works on and off according to the set time
2. Voltage: AC 100V-250V, can be used for 100V/110V/120V/127V/220V/230V/240V mains.; Power consumption: <1.0W; Output: Active output with the same output voltage as the input voltage. Do not exceed 10A at most
3. Output: Active output with the same output voltage as the input voltage. Do not exceed 10A at most.; Life: 100,000 movements
4. Input: Passive switch input, the green light will be on first after starting, and will stay in red after stopping.; Time range: 0.5 seconds - 1000 minutes; Time accuracy: Range maximum * 0.001, ie 1000 resolution
5. Input (start button): Passive switch input, the green light will be on first after starting, and will stay in red after stopping. It is not necessary to start the input. You can short the two terminals with wires, so that the power will start to cycle indefinitely without buttons

Instructions:

Time can be set in both power-on and power-off states Refer photo

1.ON duration setting:
Adjust the potentiometer under RUN TIME flag clockwise to increase and counterclockwise to reduce duration.
Adjust time range setting select switch for range 0-100 and 0-1000 and Unit Setting select switch to choose between secs and mins.

2.OFF duration setting:
Adjust the potentiometer under STOP TIME flag clockwise to increase and counterclockwise reduce duration.
Adjust time range setting select switch for range 0-100 and 0-1000 and Unit Setting select switch to choose between secs and mins.

3. Start button:
Connect to the self-reset button, press once to switch to the green light, indicating that the running state, the module will automatically work according to the set running time and stop time, infinite loop. At this point, press the start button again, the module will switch to red light, indicating that it is in a stopped state.

4. Example of time setting:
Demand: 20 seconds on, 30 minutes off, infinite loop.

Settings:

(1). Set the running time range to 0-100
(2). Dial the running time unit to the second
(3). Rotate the running time potentiometer to the 20 position, which is 20/100 from the left
(4). Set the stop time range to 0-100
(5). Dial the stop time unit to the minute
(6). Rotate the stop time potentiometer to the 30 position, that is, the position from the left 30/100

Note:

The position of the potentiometer can also be quickly located by measuring the voltage. The center arm is adjusted to a minimum of 0V and the highest position is 5V. For example, you need to adjust to 20, that is, 20/100*5V=1.0V; to adjust to 30, then 30/100*5V=1.5V