3S 50A 11.1 12.6V Battery Charging Module PCB BMS Protection Board - For 3 Series lithium LicoO2 Limn2O4 18650 26650 battery - with Heatsink and Balance Function

₹348.00

In stock

SKU

BM097-3S50A-Li-ion

The lithium battery protection board uses a highly integrated intelligent lithium battery protection board integrated chip, the performance is better than the protective board composed of discrete chips.
Can complete 5 string polymer lithium battery, ternary lithium battery, lithium iron phosphate, lithium cobalt oxide, lithium manganese oxide battery charge, and discharge protection, over current, short circuit, over-temperature protection, and equalization function.
It adopts 4 milliohms ultra-low internal resistance MOS tube, which has low internal resistance and high efficiency. It is suitable for battery pack applications in different fields such as inverters, DC motors, power tools, and solar street lights.

Please select the appropriate protection board according to the actual battery type and series connection.
Before the protection board is installed, the battery must be matched well, and the old and new batteries cannot be mixed.
Please remove the cable before wiring, and connect all the wires, and then confirm that the wiring is correct before plugging in the cable. When wiring, the control wiring diagram is gradually connected from the negative pole of the battery. For the thick line, please select the appropriate square wire according to the actual load current value.
When the working current is too large, please add tin to the tinned part of the front and back of the protection board, or thicken the copper wire to increase the overcurrent capability of the circuit board.
If you need a temperature protection function, add 10K NTC resistor (refer to the image). The factory default is no temperature protection resistor.

Suitable for 3 string 18650 batteries or polymer lithium battery series combination) 10.8V (rated voltage for polymer battery) 11.1V (18650 or 3.7V lithium battery rated voltage) 12.6V (lithium battery is fully charged after the voltage)eries combination) 10.8V (rated voltage for polymer battery) 11.1V (18650 or 3.7V lithium battery rated voltage) 12.6V (lithium battery is fully charged after the voltage); additional cells can be added in parallel
Charging voltage: 12.6V - 13.6V, overcharge detection voltage :4.25±0.025V overcharge Lift the voltage:4.15±0.05V over discharge detection voltage :2.50±0.08V over discharge Lift the voltage:3.00±0.1V
Continuous charge current (upper limit): 50A; (Over 20A, please stack the tin-plated part of PCB or add copper wire to increase overflow);
Internal resistance: Less than 45 m Ω, Service life: >30,000hours
With Balancer, Short circuit protection Overcharge protection Over-discharge protection Overcurrent protection, Remove protection condition automatic recovery, without activation