W1209WK W1209 WK W1219 DC 12V - LED Digital Temperature Controller Thermostat for incubator - with waterproof NTC Sensor

Features:

Modeling simple, elegant, LCD panels inline connections, moisture-resistant, strong anti-interference, applies to refrigerated cabinets, display counters and other needs of temperature measurement and display of various equipment.

Instructions:

• Please pay attention to your first use. You need to wait for 6s after your setting data, the module will save the date you have set after 6s.

• Short press button SET: If you start the time setting mode, the Nixie tube will blink. You could adjust the time T1 and T2 by button+ and button-. Please wait for 5s after your set date, the module will save the date you have set after 5s

• Long press button SET: if you start the parameter setting mode. There are two group parameters for your choice: P0 and P1. You could switch P0 or P1 by short press SET. Under the parameter P0 and P1, you could set the timing mode by the button+ and button-.

• P0--0: timing mode is 0--999 seconds

• P0--1: timing mode is 0--999 minutes

• P0--2: timing when the pattern is 0--999

• P1--0: T1 time delay relay (T1 timer)

• P1--1: T1 delay time relay releases (T1 timer)

• P1--2: time delay relay after T1 (T1 timer), then the delay time T2 successor electrical release (T2 timing) ends.

• P1--3: T1 delay time relay releases (T1 timer), then the delay time T2 successor Electric energized (T2 timing) ends.

• P1--4: time delay relay after T1 (T1 timer), then the delay time T2 successor electrical release (T2 timer), repeat the cycle.

• P1--5: T1 delay time relay releases (T1 timer), then the delay time T2 successor Electric energized (T2 timer), repeat the cycle.

Specification: