1 Channel 5V 10A Relay Module WITH OPTOCOUPLER - AC and DC Appliance Control - for Arduino DSP AVR PIC ARM

• Normally open interface maximum load: AC 250V/10A, DC 30V/10A.

• SMD optocoupler isolation, strong driving capability, stable performance; trigger current 5mA.

• Fault-tolerant design, the relay will not move even if the control line is broken.

• Power indicator (green), relay status indicator (red).

• The interface is designed humanized, and all the interfaces can be directly connected by wiring terminals, which is very convenient.

Two module interface:

1. DC+: Connect the power supply positive pole (voltage 5V).

2. DC-: Connect the power negative pole.

3. IN: Low level (3.3V) control relay pull in.

Relay output terminal:

1. NO: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM.

2. COM: Relay common interface

3. NC: Relay normal close, short connected with COM before pulling in and suspended after pulling in.

Specification:

• Operating voltage: DC 5V; Trigger current: 5mA; Normally open interface maximum load: AC 250V/10A, DC 30V/10A.

• Trigger Type: Low = ground level = logic 0 = logical false | High = supply voltage (usually Vcc or Vdd) = logic 1 = logical true.

• This Module Is In Line With International Safety Standard, Control Areas And Load Area Have The Isolation Groove; Blue Kf301 Terminal Line More Convenient.

• Uses The Best Quality Relay; DC Or AC Signal Control, Can Control 220 V AC Load;

• Applications: Industrial Fields, PLC control, Household intelligent control;